I have a site-to-site VPN connection setup with an external client. Type the name of VPN as site-to-site-VPN.Open the SmartView Monitor and go to “Tunnels on Gateway”: First select GWA in the list and review if the tunnel in question is UP, DOWN or Up – Init. By default, the Cisco ASA 5505 firewall denies the traffic entering the outside interface if no explicit ACL has been defined to allow the traffic. By default, VPN configuration works with Simplified mode. Troubleshooting IKE Phase 1 problems is best handled by reviewing VPN status messages on the responder firewall. First of all check the VPN configuration. Introduction This post is the first in a series of two.Once you have configured the VPN, use the following commands to confirm that the VPN is functioning correctly. 0/24) and for the second VPN tunnel it will be from our headquarters (10.
0 Comments
Leave a Reply. |